NORAC UC4+SM3-4B - Manual (Page 10)

7
4
ELECTRICAL INSTALLATION
4.1 R
OLL
S
ENSOR
I
NSTALLATION
1. Mount the roll sensor (E01) to the
included roll sensor bracket using the
machine screws and nylon lock nuts, as
illustrated in Figure 4.
The roll sensors must be
mounted tightly to the brackets.
Figure 4: Mounting the Roll Sensor
to the Roll Sensor Mounting
Bracket
2. The roll sensor included in this kit is to
be mounted on the chassis as shown in
Figure 5. Ensure that the roll sensor
cabling is pointing to the right side of
the sprayer (when looking from the
rear).
3. Ensure that the roll sensor is relatively
level when the chassis is level.
4. Ensure that the chassis (Reference
Frame) roll sensor has the highest roll
sensor serial number (not including the
roll sensor with the temperature
probe).
Figure 5: Chassis Roll Sensor
Mounting Location
5. Ensure the sensor is mounted
adequately and that the cable provides
enough slack.