NORAC UC4+BC+SM4 - Manual (Page 23)

20
4.7 E
LECTRICAL
I
NSTALLATION
1. Install the UC4+ Control Panel (E01) in
the cab of the sprayer. Mount the panel
where it will be clearly visible and within
easy reach of the operator.
A good spot to mount the UC4+
control panel is on the right hand side
of the cab to the Roll Over Protection
Bar. Four pilot holes for the screws
provided need to be drilled to facilitate
the control panel mounting.
Another option is to purchase an
adapter for the flexible panel mount that
has a 3/8" NC threaded stud on the end
to bolt through an existing mount. You
can find these at your local outdoor
store as a RAM mount part number
RAM-B-236. (
http://www.ram-
mount.com/ )
Figure 21: Control Panel Mounting
Figure 22: Cable Configurations: C11, C14 and C10
ROP