NORAC UC4+BC+SM4 - Manual (Page 20)

17
4.5.3 Reference Frame Roll Sensor
Mounting
1. The reference frame roll sensor is to be
mounted on the chassis as shown in
Figure 17. Ensure that the roll sensor
cabling is pointing to the right side of
the sprayer (when looking from the
rear).
Figure 17: Reference Frame Roll
Sensor Mounting Location
2. Ensure that the roll sensor is relatively
level when the chassis is level.
3. Ensure that the Reference Frame roll
sensor has the highest roll sensor
serial number (not including the roll
sensor with the temperature probe).
4. Ensure the sensor is mounted
adequately and that the cable provides
enough slack.
Check that the roll sensors and
cables will not interfere with, or
come into contact with any parts
of the sprayer.