NORAC UC4+BC+SM4 - Manual (Page 18)

15
Figure 13: Roll Sensors Mounted on a Summers Sprayer
4.5.1 Intermediate Frame Roll Sensor
Mounting
1. It is often best to cable tie the
intermediate frame roll sensor in place.
When mounting the intermediate frame
roll sensor follow the guidelines and
refer to Figure 14.
The intermediate frame roll
sensor must be mounted on a
portion of the sprayer that does
not pivot and is as close to the
boom frame roll sensor as
possible (Figure 12).
a) Make sure you are using the roll
sensor with the temperature probe
(E03).
b) Ensure the roll sensor is level with
respect to the chassis.
c) The AMP (circular) connector
MUST exit towards the right
hand wing.
d) Make sure the temperature probe is
able to reach the side of the valve
block.
Figure 14: Intermediate Frame Roll
Sensor Mounting
2. Fasten the temperature probe to the
UC4+ valve block, using the supplied
3/8”x1/2” bolt as shown in Figure 15.
3. Cable-tie the temperature probe cable
and AMP (circular) connector securely
to a frame member.
Figure 15: Temperature Probe
Attached to the UC4+ Valve Block
Intermediate
Frame Roll
Sensor
Boom
Frame Roll
Sensor