beautypg.com

1 boom roll sensor mounting – NORAC UC4+BC+HG3 User Manual

Page 15

background image

12

Figure 14: Mounting Guidelines

Figure 15: Roll Sensor Mounting with Respect to Sprayer Orientation

4.3.1 Boom Roll Sensor Mounting

The boom roll sensor is the roll sensor
with the temperature probe attached to it
(E03). To mount the boom roll sensor
refer to these guidelines.

1. The boom roll sensor must be attached

to the center part of the boom.

2. Use cable-ties to secure the bracket to a

square edge feature (square tube).

3. The AMP (circular) connector must be

pointing to the right hand wing (when
looking from the rear).

4. The ring terminal on the boom roll

sensor is a temperature probe and must
be attached to the side of the valve block
(Section 4.3.3).

The roll sensors must
be mounted with the
Amp connectors
pointing to the right.

Chassis

Roll

Sensor

Boom

Frame

Roll

Sensor