NORAC UC4+BC+JD11 - Manual (Page 28)

25
8.2
Cable Installation
1. Connect the UC4+ power cable (C10) to the UC4+ Control Panel (E01). Route the R16
connector to the outside of the cab (Figure 26).
2. Connect P3 to a +12 VDC, 15 amp power outlet inside the cab.
3. Connect P16 on cable C11 to R16 on cable C10 and route the free ends of C11 to the rear
of the sprayer.
Figure 26: Cable Configurations: C10, C11
4. Locate the main John Deere factory wiring harness at the rear of the sprayer near the John
Deere valve block. Insert the connectors on cable C13 into the left, right and main lift
functions (Figure 27).
5. Connect the 3 pin connector on cable C13 to T3 on cable C11
6. Connect cable C03 to S6A on cable C11. The other ends of C03 will be connected to the
valve block.
Figure 27: Cable Configurations: C03, C11, C13 and C17