NORAC UC4+BC+JD11 - Manual (Page 20)

17
6.2
Roll Sensor Mounting Guidelines: Center Pivot Booms
1. When mounting the roll sensors, mount one to the boom frame (E04) and one to the non-
pivoting chassis (E03). For optimal performance, minimize the distance between the roll
sensors (A) and minimize the height from each roll sensor to the pivot point (B).
Figure 16: Roll Sensor Mounting on a Center Pivot Suspended Boom
2. Ensure the roll sensors are relatively level when the sprayer boom and chassis are level.
3. Both roll sensor cables should be pointing towards the right hand wing of the sprayer
(when looking from the rear of the sprayer).
4. Ensure both roll sensors are mounted adequately and that the cables provide enough slack
to allow sufficient boom roll.
Figure 17: Roll Sensor Mounting on a Center Pivot Suspended Boom
E03
E04