NORAC UC4+BC+JD11 - Manual (Page 19)

16
6 Roll Sensor Installation
6.1
Bracket Assembly
1. Securely mount the roll sensors to the included roll sensor brackets using the #6 machine
screw and nylon lock-nuts.
2. The orientation of the mounted roll sensor to the roll sensor bracket will depend on the
bracket mounting. The roll sensor CAN-bus connector must be pointing towards the right
side of the sprayer (when looking from the rear of the sprayer).
Figure 14: Mounting Roll Sensor to Bracket
Figure 15: Roll Sensor Orientation - Connector Facing Right Wing
* The boom frame
roll sensor does not
have a temperature
probe.