NORAC UC4+BC+JD10 - Manual (Page 28)

25
Figure 35: Alternate Cab Exit for Cabling
6. Attach the valve extension cable (C11) to
C10 (Figure 33).
7. Route the valve extension cable (C11) to
the rear of the sprayer near the sprayer
valve block. Run the cable along the sprayer
frame with the JD harness.
Figure 36: Cable Configurations: C11, C13, C17 and C03
8. Connect the variable rate valve cable (C03)
to the valve extension cable (C11) (Figure
36).
9. Install the 2-pin connectors from C03 onto
each NORAC valve as shown in Figure 33.
The connectors are marked RIGHT UP,
LEFT UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go on the
same side as the hydraulic hoses.
Figure 37: Valve Cable Connections
Cab Exit