NORAC UC4+BC+JD10 - Manual (Page 27)

24
Figure 33: Cable Configurations: C10, C11 and C14
2. Connect R10 and P4 on the UC4+ power
cable (C10) to the mating connectors on
the UC4+ Control Panel (E01) (see Figure
33).
Ensure the UC4+ Control Panel’s
power is OFF for the remaining
installation. (Bottom of switch
pressed IN).
3. Plug the 3-pin connector on C14 into the
cab’s power bar.
4. Route the free ends of C10 along the side of
the cab post and under the floor mat.
Figure 34: Hole under Floor Mat
5. Route the free end (R16) of C10 out the
hole under the floor mat (Figure 34).
The hole in the floor may be covered
by a plate, or a grommet may be
installed in the hole. They can be
reinstalled after the wiring is
complete. NORAC supplies a
grommet for the hole if one does not
exist.
The hold in the floor may be too
small for the connector. In this
situation the cable can be routed out
the back of the cab through an
opening close to the bottom of the
rear, right window (Figure 35).