NORAC UC4+BC+CS1 - Manual (Page 24)

21
Figure 25: Cable Configurations: C10 and C11
2. Connect the UC4+ power cable (C10)
to the UC4+ Control Panel in the
sprayer cab. Ensure that both plugs are
connected to the panel.
3. Connect the 3-pin AMP connector (P3)
on C10 to an auxiliary power
connection in the sprayer cab. If an
appropriate connector cannot be found,
it may be necessary to cut off the
connector(s) and splice into the existing
wiring.
Ensure the UC4+ Control Panel’s
power is OFF for the remaining
installation. (Bottom of switch
pressed IN).
4. Route the receptacle end (R16) of C10
out of the cab.
5. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to R16
of C10 on the outside of the cab.