NORAC UC4+BC+AP3 - Manual (Page 25)

22
Figure 26: Cable Configurations: C10 and C11
2. Connect the UC4+ power cable (C10)
to the UC4+ control panel in the
sprayer cab. Ensure both plugs (P16
and P4) are connected to the panel
Figure 26.
Ensure the UC4+ Panel’s power
is OFF for the remaining
installation (Bottom of switch
pressed IN).
3. Connect the 3-pin AMP plug (P3) on
C10 to the 3-pin AMP receptacle (R3)
on the power pigtail interface cable
(C14). Connect the pigtails on C14 to
a 12V power connection. Cable C14
may not be needed if there is an
auxiliary power connector to connect
the 3-pin AMP plug (P3) of C10 to.
4. Route the receptacle end (R16) of C10
out of the cab.
5. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to R16
of C10 (Figure 26).
Figure 27: Cable Configurations: C13, C03 and C04