beautypg.com

1 boom frame roll sensormounting – NORAC UC4+BC+AP3 User Manual

Page 18

background image

15

4.5.1 Boom Frame Roll Sensor

Mounting

1. Use the supplied hardware to mount

the boom frame roll sensor (E04) as
shown in Figure 18.

When mounting the boom frame roll
sensor follow these guidelines:

a) To prevent bending the bracket,

ensure bolts are placed as close
together as possible (minimize C in
Figure 18).

b) Be sure to use the roll sensor

without the temperature probe
(E04).

c) When the boom is centered (not

rolled over) the roll sensor should
be level with respect to the sprayer
chassis.

d) It is best to mount the roll sensor to

the left hand trapeze link (when
looking from the rear of the
sprayer).

e) The roll sensor AMP (circular)

connector MUST exit towards
the right hand wing
(when
looking from the rear of the
sprayer).


Figure 18: Boom Frame Roll Sensor

Mounted to a Trapeze Link

2. Cable-tie the sensor connector to the

frame with enough slack to allow the
link to rotate.

Make sure the bracket does not

collide with any parts of the
sprayer when the boom rotates.
Also ensure there is enough slack
to allow the roll sensor to rotate.