NORAC UC4.5-BC-RG6 - Manual (Page 26)

23
15. Fasten the 8-way coupler to the boom with cable ties. Connect P6 on C11 to the 8-way
coupler using cable C08 and a 2-way coupler (E12).
16. Connect both roll sensors to the 8-way coupler.
17. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
18. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
IMPORTANT:
Provide enough slack in all cables to account for the movement of the main
section, parallel lift, and FOLDING boom movement.