NORAC UC4.5-BC-GN1 - Manual (Page 29)

26
8.3 Valve Block Mounting
Ensure no hydraulic components will interfere with any sprayer parts or be pulled
tight at any time.
1. Mount the valve block on the sprayer near the existing valve block.
2. Use the supplied valve bracket B10 to install the valve block.
3. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
4. Use the remaining hardware to secure the block to the sprayer.
5. Cut off excess threaded rod, if necessary.
Figure 28: Valve Block Mounting