National Cart CCS-2766-0597B METAL COVERED CART CORRAL - Manual (Page 16)

16
H. Slide the remaining polygal panels up through each side of the remaining “H” channels and secure with
¼”-20 x 1” HHCS.
15. Repeat step 14 for opposite side of corral.
FACIA ASSEMBLY
16. Install fascia (G) to header (C) at location H1 (Diagram B). Cut center face in length of fascia (G) with tin
snips. Align the cut with peak of header (C). Bend both sides of fascia (G) down to conform with shape of
header (C). Secure lap joint at peak of header (C) with #12 x 1.0” tek screw in face. Repeat above
procedure for all bends. (NOTE: lap joint should allow water to run down the outside of unit.) Cut fascia
(G) to length after last bend and secure with #12 x 1” tek screws. Put two additional tek screws in face of
fascia (G), centered in flats between long legs of bend (total of 9 screws on face). Secure top side of fascia
(G) with #12 x 1.0” lap tek screws where maxi rib panels (E) and fascia (G) come together at each bend, at
each end, and at second rib from peak on each side (total of 9 screws on top side).
17. Repeat step 16 for location H9.