National Cart CCS-2766-0597B METAL COVERED CART CORRAL - Manual (Page 14)

14
B. Making sure that the “H” channel is centered on the header put the second screw in the bottom hole.
DO NOT OVER TIGHTEN
C. Put “C” channel (J), for polygala, over one end of a polygal panel (H) and slide up through one end of
the “H” channel and secure “C” channel on entry end header with tek screw through small (5/16”) hole
in top of “C” channel.
DO NOT OVER TIGHTEN
D. Drill Through 5/16” hole and through the polygal panel using 5/16” hole in ”C” and “H” channels as a
guide.
E. Secure polygal through the pre-drilled holes in the “H” and “C” channels with the ¼”-20 x 1” HHCS
(V), ¼” lock washer (W) and ¼” hex nut (X). There will be eight holes per piece of polygal. Repeat the
use of the “C” channel on the two entry ends of the cart corral and the two center sections.