Mytek Digital Private-Q DL Cable Assembly Using Canare MR202-16AT User Manual
Page 14
27.
Snap the other half on. It is easiest if you slide the remaining
half on upright from the side. You will have to bend the locking
tabs on top a little bit with a flathead for the two halves to snap
together. Make sure the cover tab does not get stuck under the
other half. It should sit on top. Also be sure that the cable does not
get pinched between the two halves.
28.
Insert the top part of the strain relief by placing the tab in the
hole upright, then push it down on to the cable. You might have to
spread it open a little bit.