Mytek Digital Private-Q DL Cable Assembly Using Canare MR202-16AT User Manual
Page 10
19.
Solder the remaining ground and -29V wire. Ground should
come in from the right side and wire 16 from the left. This is tricky
so be patient and take your time to make sure that you do not
solder the rows together and short them.
20.
Insert wires 6 and 12 now. Refer to the DL pinout diagram
which can be found in the PQ manual or at the end of this guide.
The colored wire is +, the clear copper wire is -, and the silver wire
that you put clear heatshrink over is the shield.