Cisco WVC80N - Manual (Page 17)

Chapter 3
Advanced Configuration with the Web-based Utility
16 Wireless-N Internet Home Monitoring Camera
Max Frame Rate Select the maximum frame rate for the
camera. Reducing this lowers the amount of bandwidth
required by the camera. The range is from 1 to 30.
NOTE: Video quality and/or performance may
be affected by the number of users connected
to the Camera.
It may be helpful to know the bit rates for video viewing or
recording at different resolutions and image quality levels.
The following table lists these estimated bit rates.
Estimated Bit Rates for Video Viewing or Recording
Resolution Quality Level Bit Rate in kbps
640 x 480 Very High 4000
640 x 480 High 3200
640 x 480 Normal 1200
640 x 480 Low 480
640 x 480 Very Low 160
320 x 240 Very High 1000
320 x 240 High 800
320 x 240 Normal 300
320 x 240 Low 120
320 x 240 Very Low 40
160 x 120 Very High 800
160 x 120 High 400
160 x 120 Normal 200
160 x 120 Low 100
160 x 120 Very Low 40
Mobile Settings
Enable Mobile Streaming Select this option to enable
video streaming to a mobile device.
Video Adjustments
Power Line Frequency Select the power line frequency
(50Hz or 60Hz) used in your region, to improve the picture
quality under fluorescent lighting.
White Balance Select the desired option to match the
current environment and lighting.
Brightness If necessary, you can adjust the brightness to
obtain a better image. For example, if the camera is facing
a bright light, the image may be too dark. In this case, you
can increase the brightness. You can select a Brightness
value between -3 and 3.
Sharpness Select the desired option for the sharpness.
You can select a Sharpness value between -3 and 3.
Options
Enable Microphone Select this to enable audio. Using
Audio increases the bandwidth requirements slightly.
Enable Time Stamp Select this to display a time stamp
on the video.
Enable Text Display To display text on the video, select
this, then enter up to 20 characters in the field.
To save your changes, click Apply. To cancel any unsaved
changes, click Cancel. To get additional information about
the screen’s features, click Help.
Setup > Administration
The Setup > Administration screen allows you to change
the Camera’s login name and password, reset the factory
defaults, upgrade the firmware, and set the language.
Setup > Administration
Login
These fields are used to change the login name and
password used to access the Camera. For security purposes,
you should change these from the default values (both set
to admin).
Login Name Enter the login name for the Camera.
Password Enter the password for the Camera.
Verify Password Re-enter the password to verify.
Restore Factory Defaults
Restore Defaults To restore the Camera to its factory
default settings, click Restore Defaults.
NOTE: This will overwrite the Camera’s settings
with the factory defaults. Any changes you
made to the Camera’s settings will be lost; you
will not be able to recover them.