Microtel DialStat (No Fault Indicators) - Manual (Page 19)

MICROTEL DialStat
TM
15
Configuring Fault Inputs
The DialStat
TM
features true modularity—Fault input channels operate completely
independently of each other. Using the following commands, each Fault Input in your
dialer can be configured to operate uniquely to satisfy your application requirements. For
each Fault Input, record a voice message, program an alarm integration delay, and define
Normal State.
z I/O Channel Voice Name An individual I/O channel’s spoken voice name.
*c1 Play I/O channel c voice name
**c1~ Record I/O channel c voice name
NOTE: User cannot record a voice message for the Power Fault channel 5
Sample Message- Channel one normally open digital input.
A new channel name can be recorded with the '**c1' command. Once the command
is typed record your voice message after the dialer prompts you “Ready”. A
maximum of 6 seconds of recording time is allowed for each fault input message.
z I/O Channel Fault Delay When channel c changes state, this timer delays an alarm
until the channel has been in the alarm state for this many seconds (SS). This
parameter will filter out noisy, or temporary, state changes from placing undesired
nuisance alarm calls.
*c2
Report I/O channel c delay
**c2SS Program I/O channel c delay
Example- Command: **1230
Response: Channel one fault delay is three zero.
z I/O Alarm Configuration Selection of channel c normal state (OPEN or
CLOSED)
*c3
Review I/O channel c alarm configuration
**c31/0 Program I/O channel c alarm configuration
Example- Command: **131
Response: Channel one normal state is open
Example- Command: **430
Response: Channel four normal state is closed