Microtel CellStat v.1.22 - Manual (Page 19)

MICROTEL CellStat
TM
17
z Answer Delay The number of rings the dialer will see before answering an incoming
call on the telephone line. NOTE: Incoming calls on the cellular interface are
answered after 1 to 3 rings.
*02 Review
answer delay
**02nn Program answer delay
Example- Command:
**0205
Response: The telephone answer delay is zero five rings.
z Access Code This 2 digit access code is required to access configuration commands
during a telephone call to or from the dialer.
*03 Review value of access code
**03nn Program access code
NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable
access code requirement. Access code is not required to configure the dialer through
the local PHONE jack.
Example- Command:
**0313
Response: The access code is one three.
z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-
arm an acknowledged alarm and begin calling again as a reminder that the alarm
condition still exists.
*04
Review snooze delay time interval
**04HH Program snooze delay time interval
Example- Command:
**0412
Response: The snooze delay is one two hours.
z Firmware Version
*05 Report
Firmware Version
Response will play back all resident vocabulary, then speak “Cell Stat number one
two two”, where “one two two” is the current Firmware version (e.g. 1.22).
Configuring Fault Inputs