MF Digital CD-3703 (Rev: 08/01/02) - Manual (Page 18)

CD-3706/P
Operator’s Guide
Document Revision: 030501.1 CD-3000 Series Operator’s Guide
Document Revision: 100102
Page 17
1 = M U L T I P L E I M A G E S
S E L E C T O P T I O N
The factory setting for this function is disabled. When enabled, the
Multiple Images feature allows up to four images to be stored on the
hard disk drive at one time. This setting will remain in effect until
disabled, even after restarting the 3000 Series.
2 = C L I C K D E T E C T I O N
S E L E C T O P T I O N
The factory setting for this function is “enabled”. When “disabled”, the
Click Detection feature allows masters with small random errors to be
read to the hard drive. Caution should be taken when disabled, as
masters that would normally be rejected will be allowed to be read-in.
Undesirable results may occur.
3 = C O P Y P R O T E C T I O N
S E L E C T O P T I O N
The factory setting for this function is “disabled”. When “enabled”, the
Copy Protect feature will write copy protection information into data
discs copied by the 3000 Series.
• Not used.
• Press the “4” key on the keypad. The screen will now read:
S T A R T L O A D E R T E S T E R ?
[ S T O P ] = N O [ S T A R T ] = Y E S
When selected, the Loader Test Mode function allows you to manually
control the robotic functions of the system, for troubleshooting and
testing purposes.
[ 0 ] = C [ 1 ] = I [ 2 ] = A [ 3 ] = R
S E L E C T T E S T
• The “0” key recalibrates the picking arm
• The “1” key will load a disc from the input spindle
• The “2” key unloads the disc
• The “3” key rejects the disc