MF Digital Rimage Prism Plus Thermal - Manual (Page 14)

Page 14
Director EC Office Publisher
with Prism PLUS Printer
Installation Guide
Document Revision: 12/28/2004
Aligning the Prism PLUS Printer
(fig. 3)
(fig. 4)
(fig. 5)
Alert:
Before starting the Alignment Utility,
position the back end of the inkjet printer
in line with the dotted line on the top of
the drive bay.
1.
From the Start Menu Open the SCRIBE EC
Alignment Utility. It will be located in the
folder designated when you installed the
alignment utility. Choose the appropriate COM
Port Number, which the Scribe EC Loader is
connected to then choose the All other printer
types or drive’s bay then Click the Start Test
button (fig. 1).
2. Follow the onscreen instructions then Click
Yes button (fig. 2). The picker arm will then
hover a disc over the open printer tray.
Observe disc’s position and make the
appropriate adjustments to the printer (fig. 3).
3. Click Yes when you are satisfied with your
adjustment (fig. 4).
4. The picker arm will then place a disc onto the
printer tray. Follow the on screen instructions
then click the OK button (fig. 5).
5. Once you are satisfied with the printer’s
alignment, tighten the thumbscrews located on
both side of the printer (fig. 6).
(fig. 1)
(fig. 6)
(fig. 2)