beautypg.com

Procedure – Maxim Integrated Alameda (MAXREFDES24) LX9 User Manual

Page 6

background image

Alameda (MAXREFDES24#) LX9 MicroBoard Quick Start Guide

6

4. Procedure

1. Connect the Alameda board to the J4 and J5 ports of an LX9 MicroBoard as

shown in

Figure 1

.

2. Connect the +24V power supply positive terminal and the ground terminal to the

+24V and the PGND connectors on the Alameda board, respectively.

3. Connect one end of the 750

Ω load resistor to the OUT1 connector on the

Alameda board. Connect the other end of the 750

Ω load resistor to the AGND1

connector on the Alameda board.

4. Verify that the JU1, JU3, JU5, and JU7 jumpers are on the 2-3 position.

5. Verify that the JU2, JU4, JU6, and JU8 jumpers are on the 1-2 position.

6. Connect the J3 USB connector of the LX9 MicroBoard to a PC. This connection

is used to communicate with a PC through a terminal program. See step 16 for
USB driver installation.

7. Connect the J6 JTAG connector of the LX9 MicroBoard to a PC through a Xilinx

programming cable. This connection is used to program and debug the FPGA.

8. Download the latest RD24V01_00.ZIP file at

www.maximintegrated.com/Alameda

. All files available for download are

available at the bottom of the page.

9. Extract the RD24V01_00.ZIP file to a directory on your PC. The location is

arbitrary but the maximum path length limitation in Windows (260 characters)
should not be exceeded.

In addition, the Xilinx tools require the path to not contain any spaces.

C:\Do Not Use Spaces In The Path\RD24V01_00.ZIP

(This path has spaces.)


For the purposes of this document, it will be C:\designs\maxim\RD24V01_00\.
See

Appendix A: Project Structure and Key Filenames

in this document for

the project structure and key filenames.