Craftsman 137.21241 - Manual (Page 8)

8 9 8 9
ACCESSORIES AND ATTACHMENTS TOOLS NEEDED FOR ASSEMBLY
RECOMMENDED ACCESSORIES
● Use only accessories recommended for
this miter saw. Follow instructions that
accompany accessories. Use of improper
accessories may cause hazards.
● The use of any cutting tool except 10 in.
saw blades which meet the requirements
under recommended accessories is
prohibited. Do not use accessories such
as shaper cutters or dado sets. Ferrous
metal cutting and the use of abrasive
wheels is prohibited.
● Do not attempt to modify this tool or
create accessories not recommended for
use with this tool. Any such alteration or
modification is misuse and could result in
a hazardous condition leading to possible
serious injury.
ACCESSORIES
Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase
recommended accessories for this power tool.
● To avoid the risk of personal injury, do not
modify this power tool or use accessories
not recommended by Sears.
● Read warnings and conditions on your
CARBIDE TIPPED SAW BLADE. Do not
operate the saw without the proper saw
blade guard in place. Carbide is a very
hard but brittle material. Care should be
taken while mounting, using, and storing
carbide tipped blades to prevent accidental
damage. Slight shocks, such as striking
the tip while handling, can seriously
damage the blade. Foreign objects in the
workpiece, such as wire or nails, can also
cause tips to crack or break off. Before
using, always visually examine the blade
and tips for bent blade, cracks, breakage,
missing or loose tips, or other damage. Do
not use if damage is suspected. Failure to
heed safety instructions and warnings can
result in serious bodily injury.
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped
over (see dotted figure).
WARNING
!
WARNING
!
SUPPLIED NOT SUPPLIED
Adjustable Wrench
Combination Square
Philips Screwdriver
Slotted Screwdriver
Blade Wrench
Draw light line on
board along this
edge.
Straight edge or
a 3/4 in. board,
this edge must be
perfectly straight.
Gap from untrue square when
flipped over.
Hex Key