Assembly and adjustments, Warning – Craftsman 137.21241 User Manual

Page 12

WARNING

ASSEMBLY AND ADJUSTMENTS

ASSEMBLY INSTRUCTIONS

To avoid injury, do not connect this miter

saw to the power source until it is completely

assembled and adjusted and you have read

and understood this Operator’s Manual.
ASSEMBLE STAND (FIG. A-1, A-2, A-3)

1. Unpack all parts and group by type and size.

Refer to parts list on page 9 for quantities.

2 Identify the two long-upper supports: (7) &

(8), in which the distance between 2 bolt

holes of front upper support (7) are shorter

than the one of rear upper support (8). (Fig. A-1)

Fig. A-1

3. Attach the front long-upper support (7) to two

upper legs (1) by using caphead square neck

bolt (10) for the outside and tooth ﬂange

nuts (13) for the inside. Repeat this step to

assemble the rear long-upper support part.

(Fig. A-2)

NOTES:

a) Position all supports to the inside of the

leg assemblies.

b) Do not tighten bolts until stand is properly

aligned (see step #9).

Fig. A-2

4 Joint front and rear frames sections by using

two short-upper supports (4), using bolts (10)

and nuts (13).

NOTE: Place both the long-upper supports

(7) & (8) above the two short-upper supports

(4).

5 Attach one short-bottom support (3) to the

inside of one upper leg (1), and meantime

attach one lower leg (2) to the outside

of upper leg (1). With this three parts

overlapped, use bolts and nuts to attach the

stand leg assemble. Repeat the step to ﬁnish

the other three stand leg constructions.

6 The front and rear lower brackets (5) & (6)

must be assembled using caphead square

neck bolt (10) and tooth ﬂange nuts (13).(Fig.

A-3) Connect on both top and side of support.

7 Attach the conjunct long-bottom supports

to the INSIDE of lower legs (2), and both its

ends should be placed under the

short-bottom supports (3). Using bolts and

nuts to attach them.

8. Place one foot pad (9) on the bottom of each leg.

9. Place stand on level surface and adjust, so

all legs are contacting the ﬂoor and are at

similar angles to the ﬂoor. Tighten all nuts.

ASSEMBLE MITER SAW TO STAND (FIG. A-4)

1. Carefully place the miter saw on top of stand.

2. Line up the four mounting holes in the saw

base to the stand.

Fasten the saw to the assembled stand using

the four hex head bolts (12) and four ﬂat

washers (11) on top of the saw and four tooth

ﬂange nuts (13) under the saw bracket.

4. Tighten all nuts. (Fig. A-4)
NOTE: DO NOT OVER TIGHTEN THE LOCK

NUTS HOLDING SAW TO THE STAND. THIS

COULD DAMAGE THE SAW BASE.
Fig. A-4

Fig. A-3

��

�

��

�

��

�

��

�

FRONT

Front upper support

Rear upper support

Bolt holes