beautypg.com

4 getting started with flash programming, 1 via the gui, Getting started with flash programming – Maxim Integrated 78M6618 PDU1 Firmware User Manual

Page 12: Via the gui

background image

78M6618 PDU1 Firmware Quick Start Guide

UG_6618_122

12

Rev.0

4 Getting Started with Flash Programming

4.1

Via the GUI

If the Firmware includes a Boot Loader, the following steps describe how to use the GUI to upgrade the
Firmware using the Boot Loader:

1. On the SAI Commands tab, click the Invoke Boot Loader Mode button near the lower-left corner.


2. Power cycle the device, or send “Watchdog Reset” command. It will enter the Boot Load mode. This

can be verified by observing the DIO4 pin, which produces 15 ms pulses when the boot loader is in
operation.

See also other documents in the category Maxim Integrated Hardware: