Malone MPG460G 2010 - Manual (Page 7)

800-295-0042 ext 206 [email protected] 7
01-2010 MPG460G
7. Installing the rear tongue support
bracket. First we lay the tongue back in
its place making sure its upside down.
Push the large wire protection grommet
into the rear tongue support bracket hole,
then pass the wires through the grommet.
Install the 4-1/2” long x 1/2” bolt up from
the bottom through the tongue support and tongue. Be careful not to pinch
the wires. Add a washer and nut. Hand tighten only.
8. Bolt the tongue support to the frame
rails using 3/8” x 1” carriage head bolts.
Note the square heads go on the out-
side with the square holes in the frame.
Assemble with washers and nuts on the
inside. Hand tighten only.