Make Noise Wogglebug - Manual (Page 9)

Patch Ideas:
Tame The Bug
Set Ego/Id Balance to 9 o’clock. Patch a master clock to the External Clock INput. Attenuate all CVs at
destinations.
Basic Random Sequencing
Patch Clock OUTput to STRIKE in on Optomix, Stepped Random output to 1v/oct input on DPO. Patch DPO
output to same Optomix channel Signal input. Adjust Speed Panel Control and Ego/Id Balance Control to
taste.
Sample and Hold
Patch signal to be sampled to Ego Input. Set Ego/Id balance full CCW. Take S/H output from Stepped CV
OUTput. Set sample rate with Speed panel control, or use the External Clock INput. Add uncertainty by
turning Ego/Id Balance clockwise until completely random at full CW. Use the slewed version of the signal
by patching from the SMOOTH CV OUTput.
Jittery Clock
Patch Stepped Random Output to Speed CV INput, adjust Speed CV INput Attenuator to about 8 o’clock.
Add more or less jitter by increasing the attentuator value.
Chaotic Clock
Same as above but adjust Speed CV INput Attenuator to about 12 o’clock.
Make Noise
Remove cable from Speed CV input. Adjust Speed panel control and Speed CV Input Attenuator both full
CW so the Wogglebug runs at audio rate. Monitor any CV or audio output for different flavors of noise.
Adjust overall rate with Speed Panel Control and Speed CV Input Attenuator.
Pitch-to-Voltage (PLL)
Adjust Ego/ID control to EGO. Patch a waveform output from a VCO, such as the DPO sawtooth, to the
Influence Input. Sequence the VCO. Take the Woggle CV output for a slightly random voltage that “follows”
the sequence. Woggle and Ego/Id Panel Controls will allow some control over the degree and type of
following.
Lag Processor/Slew Limiter
Apply voltage to be slewed to Ego input. Adjust Ego/Id panel control to full Ego. Patch audio rate clock to
External Clock INput. Take the slewed output from the SMOOTH Random CV out. The Slew rate is set by
Speed Panel Control.
BitCrush
Adjust Speed Panel Control until the internal clock is at audio rate. Apply a signal to be crushed to Ego/Id
input. Start with panel control at full Ego and monitor the Stepped Random OUTput.
Dirty CV
Patch CV of your choice to Ego/Id Input. Adjust the Speed Panel Control and the Speed Input Attenuator full
clockwise for audio-rate clock speed. Adjust Ego/Id Balance to taste (further clockwise will be filthier.)