Make Noise Rosie - Manual (Page 7)

The Line Output
The LINE out level is clean up to about 75%, where it will start to overload and clip. The OVL (overload)
indicator will light to indicate this clipping. The LINE Out is a Tip Ring Sleeve jack the provides a Stereo
output on a single jack. It is also OK to use this output as a Mono output by using a Tip Sleeve jack. The
LINE out level is clean up to about 75%, where it will start to overload and clip. The OVL (overload)
indicator will light to indicate this clipping. This output is capable of driving loads typical of Headphones,
long cables runs to a mixer and just about any line level input.
The Cue Output
Cue output will always be opposite of the Line output. So when crossfader is set for CH. A the CUE
automatically cues up ch. B so you could monitor another part of the patch to prepare to fade into the
live Line output. In other words, plug headphones into CUE and plug the Line OUT to your PA system.
The cue signal is not routed to the fx Send because you would not want the audience to hear your cue
signal. The module is designed for use in a small live system allowing for setting up patches/ live patching
while audience hears the patch that is already in progress.