Make Noise René - Manual (Page 3)

Installation:
The Make Noise René is an electronic analog control signal generator requiring 80mA of
+12V regulated power and properly formatted distribution receptacle to operate. It is
designed to be used within the euro format modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm for the details of this format.
To install, find 34HP of space in your euro‐rack synthesizer system, plug the 16pin power
cable into the euro‐rack style power distribution board, minding the polarity so that the RED
stripe on the cable is oriented to the NEGATIVE 12 volt (‐12V) supply line. This is USUALLY
at the bottom. Please refer to your case manufacturers' specifications for location of the
negative supply.
PLEASE contact Make Noise with any questions regarding Powering of René.