Make Noise Function - Manual (Page 5)

Function Panel Controls (cont’d)
8. Both CV IN: Bi-Polar Exponential control signal input for entire FUNCTION. Contrary to the Rise and
Fall CV IN, BOTH has an Exponential response and Positive control signals decrease total
time while Negative control signals increase total time.
9. Fall CV IN: Linear control signal input for Fall parameter. Positive control signals increase Fall Time.
Negative control signals decrease Fall Time with respect to the Fall panel control.
10. Vari-Response Panel Control: Sets the response curve of the voltage function. Response is
continuously variable from Logarithmic through Linear to Exponential to Hyper-Exponential. The
Tick mark shows the Linear setting.
11. HANG IN: Gate or Pulse applied to this input will stop the circuit dead in its tracks. Use for
programming S&H, Track and Hold, Stepped Functions, Stepped LFOs,
synchronized Functions.
12. LED indicates activity within the circuit.
13. Non- Inverted Signal OUT: Non-inverted signal from the FUNCTION circuit. Buffered and capable of
accurately driving a 4 way multiple. 8V peak to peak when Cycling. Otherwise this output will
follow the amplitude of the input.
14. EOR/ EOC LED: Indicates the states of the EOR and EOC outputs. When RED EOC is HIGH and
EOR is LOW. When Green EOR is HIGH and EOC is LOW.
15. End Of Rise OUT: Goes high at the end of the Rise portion of the function. 0V or 10V.
16. End Of Cycle OUT: Goes high at the end of the Cycle (or Falling) portion of the function. 0V or 10V.
17. Inverted Signal OUT: Inverted signal from the FUNCTION circuit. Buffered and capable of accurately
driving a 4 way multiple. 8V peak to peak when Cycling. Otherwise this output mirrors the input
amplitude.
1 2
3
5
9
15 16 17
4
6
8
11
7
12
13
10
14