Make Noise Function - Manual (Page 4)

Function Panel Controls
1. Signal IN: Direct Coupled input to circuit. Use for Lag, Portamento, S&H, T&H and ASR (Attack
Sustain Release type envelopes).
2. Trigger IN: Gate or Pulse applied to this input will trigger the circuit regardless of activity at the Signal
IN. The result being a 0V to 8V function, aka Envelope, whose characteristics are defined by
the Rise, Fall, and Vari-Response parameters. Use for Envelope, Pulse Delay, Clock Division,
LFO Reset (only during Falling portion).
3. CYCLE LED: Indicates CYCLE ON or OFF.
4. CYCLE Button: Causes the circuit to self-cycle, thus generating a repeating voltage function, aka
LFO. Use for LFO, Clock, VCO.
5. Rise Panel Control: Sets the time it takes for the voltage function to ramp up. CW rotation
increases Rise Time.
6. Rise CV IN: Linear control signal input for Rise parameter. Positive Control signals increase Rise
Time. Negative control signals decrease Rise Time with respect to the Rise panel control
setting.
7. Fall Panel Control: Sets the time it takes for the voltage function to ramp down. CW rotation
increases Fall Time.
1 2
3
5
9
15 16 17
4
6
8
11
7
12
13
10
14