Citizen Systems CLP-9001 User Manual

Page 36

Chapter 4 Media (Paper) and Ribbon

− 26 −

9. Close the right side cover and then close the front cover, allowing the magnetic catch to firmly hold the

front cover.

The ribbon is now loaded.

NOTE

The following procedure may help you load the ribbon more easily. First insert the bobbins into the source

and destination ribbon cores, affix the adhesive tape at the end of the ribbon and then wind the ribbon

around the bobbin until the tape is hidden. Finally, set the ribbon by passing it through the lower side of the

printhead block.

CAUTION

Be sure to wind the ribbon sufficiently over the adhesive leader (or clear adhesive tape) being

fastened to the end of the ribbon before closing the right side cover.