Longshine LCS-883C-IND - Manual (Page 16)

10Base-T to 10Base-2 Converter
Desktop Installation
Follow the instructions listed below to install the
Converter onto a desktop location.
1. Locate the Converter in a clean, flat and safe
position that has easy access to AC power.
2. Affix the provided rubber pads to the bottom of
the Converter for grip, and to protect the case
from scratching.
3. Apply power to the Converter. (The green PWR
LED on the front panel should light).
4. Connect cables from the network partner
devices to the ports on the front panel. (The
green LNK LED on the front panel associated
with the port should light).
This Converter can also be mounted on a vertical
surface. Simply use the underside of the unit as a
template to measure and mark out the position of the
holes on to the surface where the unit is to be
installed. Then use the two screws provided to mount
the Converter firmly in place.
Warning
Please exercise caution when using power
tools. Also, install this unit away from damp or wet
locations, or in close proximity to very hot surfaces.
These types of environments can have a detrimental
effect on the converter and cables. An ideal location is a
lightly cooled place such as a typical equipment room.
-12-