Levana Jena V2 Manual - Manual (Page 9)

9
SETUP
Battery Installation - Monitor
1. Gently remove the BATTERY COMPARTMENT COVER on the back of the monitor
by sliding down.
2. Insert the included rechargeable battery, plug the battery cord into the small jack
on the inside of the battery compartment.
3. Slide the BATTERY COMPARTMENT COVER back into place.
4. For extended periods of non-use, please remove battery from baby monitor.
Battery Installation - Camera
The camera unit can be powered using 4 AAA batteries instead of the
included adapter
1. Gently remove the BATTERY COMPARTMENT COVER on the bottom
of the camera base, using a small phillips (cross) head screwdriver.
2. Insert 4 AAA batteries in the compartment (not included), paying
close attention to the labelled polarity markings.
3. Replace the battery compartment cover using the small screwdriver.
4. The POWER LED will flash when the battery charge is low.
Get the Most Out of Your Rechargeable Battery
Fully charge battery (4 hours) before first use.
To maximize battery life, charge battery before
battery is fully drained.
Avoid extreme heat or cold as this will affect the life
of the battery.
Turn LCD screen OFF; press POWER button on the
side of the monitor ONCE.
VOX PEEP Mode: After 1 minute of inactivity, monitor
enters standby/sleep mode (when activated).
Adjustable Brightness: Decreasing screen brightness
will extend battery life.
1
2
3
Battery
Compartment
cover