Levana Jena V2 Manual - Manual (Page 13)

13
Placement of the Monitor
The monitor can be used three different ways; placed on a tabletop, attached to your belt or mounted
on the wall.
• Set up the monitor on a tabletop by turning the belt clip DOWN and use the clip as a support stand.
• Carry the monitor on your belt by turning the belt clip UP on the back of the monitor and slide the
clip over your belt.
• Hang the monitor from a screw on the wall using the screw mounting hole in the belt clip.
Placement of the Camera
This camera can be placed on a tabletop or hung on the wall above the area being monitored.
• Place the camera within 15 feet of the area being monitored for best picture results.
• Do not place objects within 2 feet of the field of vision of the camera as
the night vision will not activate correctly if objects are too close.
Mounting the Camera on a Tabletop Safely:
1. Place the camera on a tabletop no less than 3 feet away from your
baby’s crib.
2. Feed the power cord down the back of the table or use wall clips
(not included) to secure the cord away so the baby cannot reach it.
3. Plug in the power cord, check the monitor to ensure that you are
getting a good view of your child and there are no obstructions.
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard. Power cords should be kept no less than 3 feet away from the crib and the baby’s reach at all times.
OPERATION
3 ft