Leslie Controls D Series - Manual (Page 2)

CFTIIP-015
Rev.0
__________________________________________________________________________________
This document is the property of Circor Flow Technologies India Pvt Limited should not copied or
reproduced in one form or another.
Page 2 of 15
1 General Information
The following instructions are designed to assist in
unpacking, installing and performing maintenance
as required on Circor D-series control valves.
Product users and Maintenance personnel should
thoroughly review this bulletin prior to installing,
operating or performing any maintenance on the
valve.
To avoid possible injury to personnel or damage to
valve parts, WARNING and CAUTION notes must
be strictly followed. Modifying this product,
substituting non-factory parts or using maintenance
procedures other than outlined could drastically
affect performance and be hazardous to personnel
and equipment and may void existing warranties.
WARNING: Standard industry safety practices
must be adhered to when working on this or any
other process control product. Specifically, personal
protective and lifting devices must be used as
warranted.
2 Terms Concerning Safety
The safety terms DANGER, WARNING,
CAUTION and NOTE are use in these instructions
to highlight particular dangers and/or to provide
additional information on aspects that may not be
readily apparent.
DANGER: indicates that death, severe
personal injury and/or substantial property
damage will occur if proper precautions are
not taken.
WARNING: indicates that death, several
personal injury and/or substantial property
damage can occur if proper precautions are not
taken.
CAUTION: indicates that minor personal
injury and/or property damage can occur if proper
precautions are not taken.
NOTE: indicates and provides additional technical
information, which may not be very obvious even
to qualified personnel
.
3 Unpacking
1. While unpacking the valve, check the packing
list against materials received. Lists describing
valve and accessories are in each
shipping container.
2. When lifting the valve from shipping container,
use the lifting lugs attached to the bonnet bolting.
Take care to position lifting straps to avoid damage
to the tubing and mounted accessories.
WARNING: When lifting a valve using the
lifting lugs, be aware that the center of gravity may
be above the lifting point. Therefore, support must
be given to prevent the actuator from rotating.
Failure to do so can cause serious injury to
personnel, damage to the valve or nearby
equipment.
3. Contact your shipper immediately if there is
shipping damage.
4. Should any problem arise, contact your Circor
representative.