Lake Lite LL-SML-X - Manual (Page 2)

CAUTION: CONTAINS NICKEL-CADMIUM BATTERIES. BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
NOTE:
1. LED Light inside is activated by darkness, Unit must be in a dark area before light will activate. Place in dark room to test unit.
2. Battery must be charged in order for the LED Light to turn on. Make sure battery is connected inside and then place in sunlight to charge.
NOTE: BATTERY MUST BE INSTALLED TO FUNCTION
Mounting your Light to a Surface
1. Purchase desired mounting screws or bolts
2. Place/Space Marine Lite in desired locations on surface
3. Use pencil to mark mounting holes
4. Use electric drill with small drill bit to make pilot holes
5. Use Screw Driver or Electric Screw Driver to mount unit
Recommended Screw size #10 or #12 size 1” or Longer
2-Screws/Bolts
For each light
Tools Required
Lake Lite Inc.
2301 Fairfield Ave, Suite 107
Fort Wayne, IN 46807
Phone: 260-918-2758
Fax: 260-918-3540
E-mail [email protected]
www.lakelite.com
www.solarmarinelites.com
Solar Marine Lite
MODEL: LL-SML-X
Battery Connector
STEADY MODE
FLASHING MODE
1. Remove Battery Cover from bottom of unit.
2. Connect both sides of battery connector together
3. Push button to determine light mode steady or
flash: NOTE: light must be in a dark room or
darkness to activate.
4. Install or check that the silicone O-Ring seal is in
place and correctly in position
5. Attach and tighten the battery cover with the
provided 6-screws. Be sure to work your way
around to each screw to fully tighten.
INSTALLING THE BATTERY