LABEC Z-ZHWY-1112B - Manual (Page 9)

Laboratory Equipment Pty Ltd. 2 LEVEL INCUBATOR SHAKER 2013 VER1.01
12. Trouble-Shooting
Problem Description Possible Causes Solutions
Non-running of unit, no
display of LED indicator Failure of power supply Proper wiring of the unit
Damage of fuse Replace the fuse
No display of LED indicator,
however the unit is running High frequency interference
from other equipments Use dedicated line for the
unit
Wide fluctuation of
temperatures Refrigeration parameters not
correctly set Reset the parameters
Measured temperature is
above preset value
Frequent overtemperature
alarming Preset temperature value too
high Remove the wind inlet
cover at the back of the
unit or set the
refrigeration value to 0.5
High Noise Level Unit is not placed on flat floor Place the unit on flat floor
Platform unsecure
Fasten the four knobs on
the platform
Flask clamps unsecure Fasten the nuts of flask
clamps
13. Packing List
Upon receipt of the unit, examine if there is any damage done to the unit during
transportation. In the event of shipping damage, a claim must be filed with the
transportation carrier within 7 days of receipt.
Remove the packing material from the box, take care that the accessories are not
thrown away with the packing material. Lift the unit out of the box. Do not lift the
unit by the door handle! Check all the items have been received. Included in the
box should be the following:
Item Quantity
Main unit 1
Platform 2
Power cord 1
Fuse 2
Tool for changing platforms 1
Water tray 1
Instruction Manual 1