LABEC Z-ZHWY-1112B User Manual
Page 5
Laboratory Equipment Pty Ltd. 2 LEVEL INCUBATOR SHAKER 2013 VER1.01
3. Control Panel
4. Starting the Unit
Turn on the power to the unit by pressing the Main Switch located on the right side
of the unit body, the unit enters into the running mode. All keys on the control panel
are activated in the running mode. The LED Display shows the preset temperature,
speed, timer and finally, measured temperature. Press the
Start/Pause
key, the unit
will operate on the preset parameters. Second press the
Start/Pause
key while the unit
is running stops the operation. Holding the
Power On/Off
key for more than 3 seconds,
the unit is powered off.
5. Temperature Control
Temperature of the unit can be set from ambient-20°C to 60°C. Temperature setting is
completed by the following steps:
1. Press the
Set/Confirmation
key, then press the
Increase
key to enter the
password 3.
2. Press the
Temperature
key, the unit enters into temperature setting mode.
Temperature value can be set via the
Increase/Decrease
key. To confirm the
new setting, press the
Set/Confirmation
key.
Setting of a new value overwrites the old value in the memory.