Kuzma AIR LINE 2007-6 - Manual (Page 16)

16
Spread cloth over the platter under the blue bearing and from bottle, squeeze alcohol
on to the inside of the bearing, which will then drain on to the cloth. You will hear
bubbling noises of the air coming through it. After a few minutes, shaft and bearing
will be dry and you can gently slide back the bearing. Move it a few times back and
forth. Fix back plate.
Be careful to also insert the cueing mechanism bearing in the 'up' position. Press
gently and fix it. Then align the plate vertically with the main tonearm base. If the
cueing mechanisem is too hard to move, unlock the plate so there is less pressure
against it.
Check loops and, if necessary, push back a little bit of wire. The wire loop should be
long enough, but if it is too long the loop will wobble.
Compressor- transportation:
If you can ensure the compressor will be in an upright position at all times it is not
necessary to remove the oil. If, however, there there is a possibility that it may be
tilted or turned upside down then the oil must be removed. To do this it is necesarry
to refer to the compressor instruction manual.
Note: First ensure that there is no pressure in the compressor and that it is
disconnected from the mains. Loosen the screw holding the rubber seal on top of the
compressor head and lift off the cover. Pour away oil and return the head cover and fix
the screw. Ensure that sealing ring is correctly positioned.