Kurgo Portsmouth Bench Seat Cover - Manual

Installation & care
Installation:
1) Clip adjustable straps
(A) around your bench seat
headrests so that the cover
aligns itself with your vehicle’s
seat.
2) OPTIONAL There is an
optional back strap (B) that
attaches around the back of
your seat, clipping together in
the back. This is for extra
fitting support in vehicles
where the seat folds down.
3) The under-seat bungee
cord (C) simply slips through
the triangle (D) and ties to
the left and right D-rings (E).
Tie straight across, leaving
no slack; tuck under the edge
of the seat. There may be
extra bungee left over!
4) OPTIONAL At the end of
the excess bungee you will
find clips (F). These are
optional, and used for extra
fitted support around the
bench portion of your
vehicle’s seat. (See figure 1)
5) Use the extra storage
pockets for anything you like!
We suggest filling them with
lots of fun dog stuff!
9.12 For more information: 877.847.3868 :: www.kurgo.com :: [email protected]
Washing instructions:
• Brush off loose dirt with a dry brush.
• As needed, wipe off with a damp sponge and mild soap.
• Rinse only, if possible. Use cold water and a sponge or rinse in a tub without soap.
• Machine wash in front-loading unit (DO NOT use machine with agitator; agitator could cause damage not covered
under warranty) with cold water and mild soap (Ivory Flakes, Woolite, Sport Wash, etc.). No detergents.
• Rinse thoroughly to eliminate soap residue.
• Lay flat to dry.
Underside details are
shown as dashed lines
From triangle (D) to
left & right D-rings (E)
To clip (F) which Fastens
underneath seat
figure 1
Become a fan of Kurgo on Facebook
so you can receive all the latest
updates, giveaways and contests.
BENCH SEAT
COVER