Kenton GPMX-16 - Manual (Page 6)

6
FACTORY DEFAULTS
If you wish to reset your GPMX-16 to factory defaults, you can do so by turning the power on whilst
holding down all three push buttons (mode, dec & inc). This will return the GPMX-16 to it’s default
settings.
‘Fd’ (factory defaults) will momentarily be displayed when this has been done.
DISPLAYING THE FIRMWARE VERSION NUMBER
Power the unit on while holding the ‘INC’ button pressed. While the INC button is held, the firmware
revision number [1xxx] will be displayed in pairs – two dashes then digits 1 & 2 then digits 3 & 4
repeated. Releasing the INC button will revert to the normal operational mode.
SPECIFICATIONS
Power Input 9V DC – switch mode mains adaptor supplied
Power consumption
200mA max, 2.1mm plug (centre positive)
MIDI
In, Out1 & Out2 (out1 & out2 give the same data out)
Inputs
16 GPI – 8 on each of 2 x 9 pin D connectors – pin 9 common ground
Outputs
16 GPO – 8 on each of 2 x 9 pin D connectors – pin 9 common
Display
3 x 7 segment display
Weight
1Kg including PSU
Dimensions
190 x 110 x 45 mm
Non-volatile memory
EEPROM (no back-up battery required)
WARRANTY
The GPMX-16 comes with a 12 month (from purchase date) back to base warranty, (i.e. customer
must arrange and pay for carriage to and from Kenton Electronics).
Brookfarm House, 1 Station Road, South Wimbledon, London, SW19 2LP, UK
Tel: +44 (0)20 8544 9200 Fax: +44 (0)20 8544 9300
[email protected] www.kenton.co.uk
firmware rev# 1001 e. & o. e.  30
th
April 2014