Kenton GPMX-16 - Manual (Page 5)

5
Although pitchbend and after-touch are not strictly controllers, when Controller number [Cn] mode is
selected, ‘pb’ will be displayed if a pitchbend message is received, and ‘af’ will be displayed if an after-
touch message is received.
If Controller value [Cv] mode is selected, and pitchbend or after-touch messages are received, their
values will be displayed.
When Receive channel & status [rC] mode is selected, the right hand 2 digits show the received MIDI
channel (if applicable) and the left hand digit operates as a received MIDI message indicator. LED
segments will flash when then following types of messages are received: Note on, Note off, Sysex,
Timing clock (MIDI clock), Start, Stop, Continue.
The top left dot (any MIDI message) operates in all modes, not just for Receive Channel & Status
mode.
To exit MIDI analyser mode, the power switch of the GPMX-16 must be turned off then on again.
Any MIDI
message
Clock start
Clock
continue
Note off
MIDI clock
Clock stop
Sysex
Note on