K-Edge K13-510-[color] - Manual (Page 5)

5
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Troubleshooting:

My computer hits my left TT bar when installed on the mount.
o Check that your TT bars meets the minimum bar width and adjust as needed.

There is a little play even when my computer is installed onto the mount with a positive click.
o With the computer installed, visually check for movement between the insert (K13-503) and the arm (K13-
511). If movement is detected slightly increase the torque of the 2x M3 x 6mm Flat Head Screws (1 N-m
Max).
 The mount moves downward when I install my computer.
o Check that the proper amount of torque is applied to the 2x M3 x 8mm bolts on the clamp.
Support/Contact:
If problem(s) persist after troubleshooting, please contact K-EDGE Support for further assistance at [email protected]
immediately. Please be sure to include your full name, phone number, and K-EDGE product purchased.