K-Edge K13-550-[color] - Manual (Page 2)

2
Mount Installation:
1. Ensure the stem and handlebars are installed, aligned, and torqued according to manufacturer’s recommendations.
2. Remove the original top cap and mounting bolt.
3. Install K13-551 on top of the stem.
4. Install, but do not fully tighten, M6 x 35mm FHCS.
5. Set the mount to your desired position (see above).
6. Carefully tighten the top cap bolt (M6 x 35mm FHCS) according to the manufacturer’s recommendations for the
headset.
7. Install K13-503 Garmin Insert.
8. Install the 2x M3 x 6mm FHCS and torque to 1 N-m MAX.
Caution: Do not over-torque the M3 x 6mm Flat Head screws.
Notes:
•
A small amount of thread lock has been pre-applied to the M3 x 6mm bolt at the factory, it is
recommended that an additional amount be added if this bolt were to be adjusted multiple times.
•
Subsequent adjustment or tightening of the M6 x 35mm headset bolt will require removal of the two M3
x 6mm FHCS bolts.
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!