K-Edge K13-500-[color] - Manual (Page 3)

3
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
NOTE: The K13-500 is factory assembled for immediate use with GARMIN Edge® computers without any adjustment
necessary, IF you intend to use the K13-500 with a GARMIN Forerunner® 310XT and 910XT computer, please follow the
steps below to adjust the insert (K13-503) to properly accept GARMIN Forerunner® computers.
Insert Adjustment:
1. Remove the 2x M3 x 6mm Flat Head Screws holding the K13-503.
2. Reposition K13-503 (see diagram above).
3. Reinstall, but do not fully tighten, the 2x M3 x 6mm Flat Head Screws.
4. Carefully torque the 2x M3 x 6mm Flat Head Screws to a Max of 1 N-m.
Caution: Do not over-torque the M3 x 6mm Flat Head screws.
Note: A small amount of thread lock has been applied to the M3 x 6mm bolt at the factory, it is recommended that
an additional amount be added if this bolt were to be adjusted multiple times.