beautypg.com

G-Shock DW-9701K-9JR User Manual

Page 2

background image

2017-2

BACKLIGHT

The backlight uses an EL (electro-luminescent) panel that
cause the entire display to glow for easy reading in the
dark. The watch's auto light switch automatically turns on
the backlight when you angle the watch towards your face.
• The auto light switch must be turned on (indicated by

the auto light switch on indicator) for it to operate.

Note
• The electro-luminescent panel loses illuminating power

after very long use.

• The illumination provided by the backlight may be hard to see when viewed under

direct sunlight.

• The watch will emit an audible sound whenever the display is illuminated. This is

caused by vibration of the EL panel when it is lit. It does not indicate malfunction of
the watch.

• The backlight automatically turns off whenever an alarm sounds.

To manually turn on the backlight

In the Timekeeping Mode, press

D

D

D

D

D

to illuminate the display for about two seconds.

The above operation turns on the backlight regardless of the current auto light switch
setting.

About the Auto Light Switch

Turning on the auto light switch causes the backlight to turn on whenever you posi-
tion your wrist as described below. Note that the auto light switch of this watch will
operate only when available light is below a certain level. It does not turn on the
backlight under bright light.
• Avoid wearing the watch on the inside of your wrist. Doing so causes the auto light

switch to operate when it is not needed, which shortens battery life.

• The backlight turns off in about two seconds, even if you keep the watch pointed

towards your face.

• The backlight may not light if the face of the watch is more than 15 degrees off the

parallel as shown below. Make sure that the back of your hand is parallel to the
ground.

Static electricity or magnetic force can interfere with proper operation of the auto
light switch. If the backlight does not light, try moving the watch back to the starting
position (parallel with the ground) and then tilt it back toward you again. If this does
not work, drop your arm all the way down so it hangs at your side, and then bring it
back up again.

Under certain conditions the backlight may not light until about one second or less
after turn the face of the watch towards you. This does not necessarily indicate
malfunction of the backlight.

Warning!

Never try to read your watch when mountain climbing or hiking in areas that
are dark or in areas with poor footing. Doing so is dangerous and can result
in serious personal injury.

Never try to read your watch when running where there is danger of acci-
dents, especially in locations where there might be vehicular or pedestrian
traffic. Doing so is dangerous and can result in serious personal injury.

Never try to read your watch when riding on a bicycle or when operating a
motorcycle or any other motor vehicle. Doing so is dangerous and can result
in a traffic accident and serious personal injury.

When you are wearing the watch, make sure that its auto light switch is turned
off before riding on a bicycle or operating a motorcycle or any other motor
vehicle. Sudden and unintended operation of the auto light switch can create
a distraction, which can result in a traffic accident and serious personal inju-
ry.

To turn the auto light switch on and off

In the Timekeeping Mode, hold down

D

D

D

D

D

for one second to turn the auto light switch

on (AUTO

displayed) and off (AUTO

not displayed).

• Frequent use of the auto light switch greatly reduces the charge of the storage

battery. If you use the auto light switch often, be sure to leave the watch where it is
exposed to sunlight during the day time so it can recharge the storage battery. 10
minutes exposure to sunlight provides enough of a charge for about 10 to 20 auto
light switch operations.

• The AUTO

indicator is on the display in all modes while the auto light switch is

turned on.

MOON DATA MODE

Be sure to set the current time and your current location before trying to use the
Moon Data Mode.
The Moon Data Mode display shows the current moon age, as well as moon up and
moon down times. Moon age is indicated both by a value and one of the following
graphics.

• The moon up time indicates when the moon will

reach its highest point relative to your current lo-
cation (upper transit), while the moon down time
indicates when it will reach its lowest point (low-
er transit). Note that moon up and moon down
times are accurate up to

±

30 minutes.

To display the moon up and moon down time for a specific date

The moon data for your home time point appears first
when you enter the Moon Data Mode.

Press

D

D

D

D

D

(forward) or

B

B

B

B

B

(back) within about two

seconds after entering the Moon Data Mode to scroll to
another point. Holding down either button scrolls at high
speed. It takes about 40* seconds before moon data
appears after you display the name of a point.

If you do not perform any button operation, about two
seconds after you enter the Moon Data Mode the
display changes automatically to show the moon data
for today’s date. Pressing

D

D

D

D

D

advances to the next date,

while

B

B

B

B

B

goes back to the previous date. Holding down

either button scrolls the date at high speed. It takes about
40* seconds before moon data appears after you dis-
play a date.

* While the countdown alarm is operating, it takes about

three and a half minutes to calculate.

Note that once you enter the moon data display, you
cannot change to another point. To change to another
point, press

A

A

A

A

A

twice to return to the point name

display, make the changes you want, and then re-enter
the moon data display.

Moon data is displayed in 5-minute units.

For days around the full moon (moon age 15) or new
moon (moon age 29.5), there are days where there is
no moon up or moon down. In such cases, the

xx

:

xx

is shown for the moon up or moon down time.

Moon

Moon

Location

Earth

Moon-UP

Moon-Down

TIDE GRAPH MODE

1. Press

A

A

A

A

A

while in the Moon Data Mode to enter the Tide

Graph Mode. The display shows the tide graph for 6:00
am on the date that was selected in the Moon Data
Mode.

2. Use

D

D

D

D

D

(forward) and

B

B

B

B

B

(back) to scroll the time in 1-

hour increments. Holding down either button changes
the time at high speed.

Note that once you enter the Tide Graph Mode, you
cannot change to another point or date. To change to
another point or date, press

A

A

A

A

A

to return to the Moon

Data Mode, make the changes you want, and then
re-enter the Tide Graph Mode.

SUNRISE/SUNSET MODE

The today’s sunrise and sunset data for your home time
point appears first when you enter the Sunrise/Sunset
Mode.

Press

D

D

D

D

D

(forward) or

B

B

B

B

B

(back) within about two

seconds after entering the Sunrise/Sunset Mode to scroll
to another point. Holding down either button scrolls at
high speed. It takes about 40* seconds before sunrise/
sunset data appears after you display the name of a
point.

If you do not perform any button operation, about two
seconds after you enter the Sunrise/Sunset Mode the
display changes automatically to show the sunrise/
sunset data for today’s date. Pressing

D

D

D

D

D

advances to

the next date, while

B

B

B

B

B

goes back to the previous date.

Holding down either button scrolls the date at high speed.
It takes about 40* seconds before sunrise/sunset data
appears after you display a date.

* While the countdown alarm is operating, it takes about

three and a half minutes to calculate.

Note that once you enter the Sunrise/Sunset data display, you cannot change to
another point. To change to another point, press

A

A

A

A

A

to return to the point name

display, make the changes you want, and then re-enter the Sunrise/Sunset data
display.

Sunrise/sunset data is displayed in 5-minute units.

Auto light switch
on indicator

Moving the watch to a position that is parallel to the ground and then tilting it
towards you more than 40 degrees causes the backlight to light.

Parallel to ground

More than
40

°

Parallel to ground

More than 15 degrees
too high

More than 15 degrees
too low

New Moon Crescent

Moon

Half Moon

First Quarter

Full Moon

Half Moon

Last Quarter

Point name

Hour

Minutes

Moon age

Moon down
time

Moon up time

Year

Month

Day

High

Ebb

Tide graph

Day of week

Month - Day

Time

Low Flood

Point name

Hour

Minutes

Sunset time

Sunrise time

This manual is related to the following products: